There are two possible ways of doing that – open the toe seam and unravel the toe shaping, then remove 4 rows and reknit the toe; or cut the foot, unravel a couple of rows each side then graft the two parts together using a 3-needle cast-off (also known as the Kitchener Stitch).
In this post
How do you reduce the toe when knitting socks?
For a standard wedge toe, I always decrease like this:
- Knit 3 rounds of plain stockinette stitch.
- Decrease every second round until there are only half of your stitches left.
- Decrease every round until you halved the stitches again.
- Finish with a Kitchener stitch.
How do you adjust a sock pattern?
Perhaps the easiest way of adjusting the sock size is knitting them with either a thicker or thinner yarn than stated in the pattern. For example, if the pattern calls for a fingering weight yarn, you can make larger socks by choosing a sport or DK weight yarn instead.
How much shorter than your foot should you knit a sock?
You should choose a size that is 10% smaller than your foot or ankle circumference. Adult socks – should have 1″ / 2.5 cm negative ease in the foot and calf circumference & 0.5″ / 1.5 cm shorter than the foot length.
What is a barn toe?
Like the two other toes in this series, the Barn Toe is created by alternating a decreasing round with one or more plain knitting rounds in the beginning. Near the end, every round is a decreasing round. Similar to the Star Toe, the Barn Toe decreasing rounds have four decrease stitches.
How long should the leg of a sock be?
A good average for most feet, is to knit the length of the foot, measurement “D”, less 2 ½ inches for the toe. For example, if the length of the foot is 10 inches, knit the foot length to 7 ½ inches, then begin your toe. Remember, the sock should fit snug!
What is a sock ruler?
The Sock Ruler is an innovative measuring tool for sock knitters that allows the sock to lie flat for accurate measuring.
How long should a sock cuff be?
6 to 8 inches
Knit the cuff to your desired length (1 to 2 inches for anklets, 6 to 8 inches for standard socks). Keep in mind that if you make very long cuffs, it may be necessary to start out with more stitches, because your leg gets wider toward the top.
What are the different sock lengths?
The 8 Most Popular Sock Lengths
- Toe Topper/Half Socks.
- No-Show Socks.
- Ankle Socks.
- Quarter-Crew Socks.
- Crew Socks.
- Mid-Calf Socks.
- Knee-High/Over-the-Calf Socks.
- Thigh-High Socks.
How do you measure feet for knitting socks?
Place a tape measure on the floor. Position the back of the heel at the zero mark on the tape, then measure to the longest toe. As with the foot circumference, make sure the sock wearer’s foot is planted on the ground so you can get an accurate measurement.
How do you calculate stitches for a sock?
If you knit from the top-down, as a rule of thumb, you’ll need to cast on around 14 or 15 stitches per needle (56 or 60 stitches total) if you have a regular woman’s size and 16 or 17 stitches per needle (64 or 68 stitches total) for a regular men’s size.
What is Kitchener stitch used for?
Kitchener stitch is a knitting technique used for grafting together two sets of live stitches, most often stockinette stitch. Instead of binding off and sewing two edges together, you can use a tapestry needle and yarn to join the stitches completely seamlessly.
Is there an alternative to Kitchener Stitch?
Like it’s cousin the Kitchener stitch, the Finchley graft is used to invisibly join two rows of live stitches. It works well to finish top down socks, bottom up mittens, top down bags, or in almost any situation where you would otherwise use the Kitchener stitch.
How do you wear afterthought heels?
Afterthought Heel: Prep
- After desired length cuff is worked, knit 2 rounds.
- Next Round: With waste yarn, knit half of stitches. These are your heel stitches.
- Slip the stitches just knit on waste yarn back onto left-hand needle.
- Re-knit the heel stitches with main yarn.
What is a crew sock length?
Crew length socks are probably the most popular socks in the drawers and wardrobes of the UK, certainly among men. Crew socks are a good few inches longer than the ankle sock and reach up to the mid-calf. Crew socks can be worn pulled all the way up or scrunched, depending on your preference.
How long is a size 7 sock?
The finished sock circumference depends on how stretchy the stitch pattern you choose for your sock is. As a rule of thumb, stockinette socks should be made with approximately 10% of negative ease.
Women.
| Shoe size (US) | Foot length (inch) | Estimated foot circumference (inch) |
|---|---|---|
| 6 | 9 | 82⁄3 |
| 7 | 91⁄3 | 9 |
| 8 | 92⁄3 | 9 |
| 9 | 10 | 91⁄2 |
How do you use the horn and twig sock ruler?
Use the center slot opening to measure as you knit—simply slip the ruler into your sock, peek through the middle, and make sure both the front and back are level and at the same height. For knitting toe up, use this ruler to measure: From toe to start of heel. From finished heel to start of cuff.
Which is easier toe up or cuff down socks?
1. Cuff-down socks have an easier cast-on. Because you’re casting on more stitches and doing so in a loop, the cast-on for a pair of cuff-down socks is a bit easier than the cast-on for toe-up socks, where you are casting on a small number of stitches in a straight line and then growing a loop outward.
What is a sock gusset?
Gusset/Instep: This is the part of the sock that runs from the heel into the main part of the foot. It can normally be seen as a triangular shaped area where shaping either side of the foot decreases the number of stitches after a heel flap.
What is the leg part of the sock called?
This wedge-shaped area is known as the gusset. The top of the foot, which is worked at the same time, is known as the instep. Pattern stitches from the leg are often continued on the instep, but not always.
What is the difference between ankle and low cut socks?
Low cut socks are minimally visible under the shoe, hitting below the ankle bone. Quarter length socks rise above the shoe and typically cover the ankle bone. Ankle socks are a few inches shorter than quarter length and also cover the ankle bone.