Basic steps for making fingerless gloves from an old sweater:
- Cut sleeves off the sweater.
- Turn a sleeve inside out, fold over 1″ of the cut edge, pin and sew.
- Hem the edge.
- Place hand inside the sleeve and pin fabric between thumb and index finger. Sew the thumbhole.
- Repeat steps to make the second glove.
In this post
How do I reuse an old sweater?
15 Ways to Repurpose Old Sweaters
- Make a Pair of Mittens.
- Make a Snug Knitted Hat or a Slouchy Beanie.
- Make a Fuzzy Pillowcase.
- Keep Your Mug Warm With a Cozy.
- Make Some Fingerless Gloves.
- Make Some Boot Toppers.
- Make a Pocket Scarf.
- Make a Bum Warmer.
How do you make wrist warmers?
What do I do?
- First cut the sleeves off an old jumper.
- Stitch along the cut edge of the sleeve to prevent fraying.
- Turn the end of the sleeve under to create a seam.
- Sew one centimetre inside the seam with a blanket stitch.
- Repeat steps three and four at the top of the sleeve.
What can I do with a felted sweater?
Wool sweaters that have been felted. A single piece of felted wool fabric can be used to make gloves, hats, or almost any other item you can think of. Felted wool keeps your hands and head warmer than most commercial products, and it wicks away water to help keep you dry during the winter.
How do you boil wool gloves?
Put the sweater in a large pot filled about three quarters of the way full of water. Bring it to a boil and let it boil for about 5 -10 minutes. Boiling the wool shrinks it and makes the knit of the sweater dense. This provides a much warmer material to make the mittens.
What can you make out of old cashmere sweaters?
Upgraded Cashmere Sweaters: 20+ Recycled DIY Projects
- A protective iPad cover.
- A case for your sunglasses or eyeglasses.
- A menagerie of children’s stuffed animals.
- Bookmarks for your old-school tomes.
- Embellished arm warmers that will make everyone ooooh and aaahhh.
How can you tell if a wool sweater is felted?
Is It Shrunken or Shrunken and Felted?
- If the wool has just shrunken down a bit, there’s hope.
- If the fibers are felted (i.e. shrunken, and tightly schmooshed together), you’re out of luck for unshrinking. Though there’s plenty of other projects you can make with the felted material (see below).
How do you boil wool to make felt?
You can create felt by boiling the wool on top of the stove. This method is a little faster than using the washing machine because the water is hotter, but the technique is the same–hot water plus agitation makes the microscopic scales on wool fiber extend and latch on to the scales of the nearest fiber.
How do you make gloves out of old socks?
Socks Into Fingerless Gloves
- Step 1: Lay Out the Sock. Get your sock and lay it out. Smooth out any bumps to prevent an uneven cut.
- Step 2: Cut! Cut at least one inch before the heel.
- Step 3: Cut for Thumb. Cut a .
- Step 4: Seam Thumb Opening. I did a blanket stitch for the thumb seam.
- Step 5: Try On. You’re done!
How do you make gloves out of non stretch fabric?
Trace your hand and arm as far down as you want the glove to go.
- Step 1: Trace your hand.
- Step 2: Add a seam allowance.
- Step 3: Cut out your glove from your fabric.
- Step 4: Use a zig-zag stitch to sew your glove together.
- Step 5: Trim the excess seam.
- Step 6: Hem the wrist opening (optional)
How do you make cloth hand gloves?
- Step 1: Trace Your Hand on a Sheet of Paper. Take your dominant hand and trace it on a piece of paper.
- Step 2: Cut Out the Master Pattern.
- Step 3: Trace Your Pattern.
- Step 4: Cut Out the Fabric.
- Step 5: Pin the Fabric Together.
- Step 6: Sew the Gloves Together.
- Step 7: Turn Inside Out.
- 5 Comments.
How do you make arm warmers out of sleeves?
Arm Warmers: T-shirt Upcycle
- Step 1: Cut Off Sleeves. Take your long sleeve shirt and cut the sleeves off.
- Step 2: Fit Them to Your Arm. All you’re doing here is fitting the sleeve to your arm better.
- Step 3: Make a Thumb Hole and Finish the Edge.
- 6 Comments.
How do you make gloves without fingers?
Use a tailor’s chalk (for dark gloves) or pen (light colors) to draw a line across your fingers. Take the gloves off and cut ¼-inch (0.64-centimeters) above your cutting line. You will be hemming your gloves so that they don’t fray. Once you hem them, they will be the right length.